The brackets are bonded indirectly to the previously created set-up cast with an individually curved, slot-filling steel wire (18x25). The torque values of a bracket base are therefore not important in this method.
|
The pre-fabricated SMART™ components.
|
The joined SMART™ components on the bracket/tooth. In the production of the transfer caps, the brackets remain bonded with the arch on the cast until the end. This procedure shows the accurate fit of the transfer caps and the accuracy of the bracket position.
|
The process of forming the plastic mold, securing the bracket position to the surface of the tooth.
|
The form-fitting individual transfer cap on the cast. The defined bracket position determines the torque and angulation of the tooth.
|
The individual transfer cap positioned on the natural tooth with a bracket. This creates a key position of the brackets in relation to the surfaces of the teeth for the treatment period that can be reproduced.
|
|
Linkuri rapideDate de contact: Strada Victoriei nr 50/9, Baia Mare
Telefon: 0745-100.497 Copyright © 2015 Adenta GmbH. All rights reserved.
|